Stripped binding holes happen, when you encounter one deal with it ASAP. If the hole is not too enlarged you can cut up some steel wool and mix it into a batch of epoxy, insert the mix into the hole and reinstall the screw. This is a pretty bomber fix for hole that isn't too far gone. For tougher cases it's best to use an insert. These brass inserts are a relatively easy fix for a stripped binding screw hole, they're less expensive than a helicoil kit and don't require any special tools to install. Sold each.
A word of caution: these inserts should be used on one hole, maybe two per binding. They aren't intended as an alternative to the Binding Freedom System. The pull out resistance of these inserts is rated at 300Kp, so they're strong, but not strong enough to secure a binding on their own.
- Used in 8mm holes.
- Internal threads match those of an alpine binding screw.
- Pull out resistance is 300Kp.
- These inserts are sold individually.
- 8mm drill bit not included.
- You'll need an 8mm (5/16") drill bit and a hammer.
- Use the 8mm bit to enlarge the damaged hole. Be sure to mark the depth (about 9mm is good) on the drill bit to avoid drilling through the ski, or better yet pick up an adjustable depth bit).
- Tap the insert (slotted side down) in and reinstall the screw. Try to keep it as straight as you can.
- If the insert sits a bit above the base after installation simply file it flush.
2 Reviews Hide Reviews Show Reviews
great binding hole solution
get the associated drill bit, easy to install and absolutely repairs a loose binding hole with great strength
Wintersteiger Binding Hole Insert
Wintersteiger Binding Hole Insert combined with Loctite EA 608 Adhesive proves a positive binding screw mount anywhere on a Ski or Snowboard Deck . Effectively saving the equipment from being tossed into a landfill .