• These sheets of sintered p-tex are glued (not melted) into bases to repair very large gouges or damaged areas. 
• The clear material is 3.75" (95mm) wide,the black material is 4.25 (110mm) wide.
• Material is 1mm thick.
• They are sold in 12 increments in any length (e.g., if you order 6-feet, you'll get an uncut 6-foot length).

How To Use

• First, cut and peel out the damaged base material using with a base template and repair knife.
• then cut a new patch from these p-tex sheets (rough side down)
• glue into place on the ski or snowboard base with epoxy.
• Clamp the patch firmly (not overly tight or the epoxy will be squeezed out) using small c-clamps and flat wood or metal plates to distribute pressure evenly over the patch.
• Allow adequate time for the epoxy to dry.
• After removing clamps and plates, re-prep and hot wax the patched base area as usual.