null

Tognar Digital Ski Hot Wax Kit (Swix) -120V (USA, CAN)

(No reviews yet) Write a Review
Was: $200.70
Now: $179.95
SKU:
TOG WAXDG

Product Overview

This wax kit includes a 120 volt wax iron intended for use in the US and Canada, if you live elsewhere please see our 230 volt model.

This kit includes a digital waxing iron, as apposed to the analog irons found in our other kits. A digital wax iron uses a microprocessor to accurately control the temperature, and quickly adjust for fluctuations; an analog wax iron uses a sensitive thermostat to keep temperatures in check, while still very accurate is is not quite to the level of a digital iron. So, if you want to know your iron temp is spot on, or just like LED readouts, you'll appreciate stepping into the digital age.

The kit includes:
  • Swix T73D Digital Wax Iron 
  • 180 grams of Swix Universal Wax
  • A six-inch Tognar Plexi Scraper 
  • Tognar Rectangular stiff white nylon brush
  • Tognar Rectangular brass brush
  • Tognar Rectangular horsehair brush
Why Wax?
  • Waxing increases the glide of your skiis or board, this is the first thing that comes to mind and scares some folks off, but with that increase in glide comes an increase in control. A waxed base tends to glide more predictably than a non-waxed base, turns are initiated and released with less resistance, and you use less energy throughout the day. 
  • Waxing protects bases from the harsh abrasion encountered while sliding across the snow, especially in icy or man-made conditions.
  • Waxing prevents bases from drying out in between ski trips.
Waxing Basics:
  1. Brush base from tip to tail with the brass brush to remove any base oxidation, old wax or debris.
  2. Set your iron to the proper temperature (recommended melt temps are usually printed on the packaging).
  3. Hold the iron vertically and touch the bar of wax to the hot base, drip wax along the length of the base.
  4. Move the iron along the base melting and spreading the dripped-on wax (be sure there is wax between the base and the iron).
  5. Allow the wax to cool for about 30-minutes.
  6. Scrape cooled wax off the base, as much as you can (the important wax is deep in the pores of the base).
  7. Brush base from tip to tail with the white nylon brush removing any residual wax.
  8. Go skiing!

 

Product Videos

Reviews

(No reviews yet) Write a Review